Contact Me!!!


down to end and the site search box

Se(e/a)med Like Time for a change!

Armed with a portable compressor, an air chisel, an air cutter and a few beers..... COO wrestling commences!

The seams created where the back seat panel was removed were seam (MIG) welded and a strut brace linking the two rear inner wheel arches was added to reduce flexing

As you can see from the top right and bottom right photos, the car already has a full rollcage providing a lot of stiffness to the body shell. Note the floor cross-brace and "sexy" Spanish number plate!

The foam-lined box tank (4 US Gallons)was later fitted into a custom fabricated frame to raise it above the boot floor (the pipework runs through the car)

Uploaded 27 October 2000 19:36:58 coo_cutting.htm

back to the top

Go for .... ORIGINAL CONTENT © John "Fatbloke" Bullas 2004 | To Link to FBR click HERE | HTMLBLUNDERS? Click Here!!!! please